
Retrofit Solutions
Teaching Old Meters New Tricks
Sure, we make a comprehensive range of great meters.
But wouldn’t it be great if you could wave a magic wand and turn many of your old meters into smart, cellular AMI devices that deliver the detailed, minute-by-minute data that makes Metron metering so powerful?
Well you can.
Metron offers a variety of retrofit solutions which enable you to install Prism registers on your existing third-party meters, giving them a new lease of life without the cost of replacing the meter bodies. Installation is quick and simple, and data starts flowing into WaterScope® immediately.
Retrofit Benefits
- Replace old mechanical registers to eliminate manual reads
- Replace radio-frequency registers to eliminate drive-bys or expensive infrastructure
- Minute-by-minute data provides deep insights into water use
- Leak detection alerts
- Irrigation violation reports
- Easy billing integration
Bring your old meters into the 21st century!
Data integration can go both ways
- If you’re deploying Metron meters and WaterScope is your primary water data platform (it should be – it’s the most powerful in the industry!), we can build integrations that pull data from third-party platforms into WaterScope.
- Or, if you prefer to use a third-party data platform, we can set it up to pull in data from your Metron meters and retrofitted meters.
Retrofit Adapters
For meters which couple magnetically to top-mounted registers, Metron has a range of adapter rings which make mounting Prism registers easy. Standard brass meters from major manufacturers can be retrofitted in this way, turning them instantly into smart cellular meters.
Contact Metron to find out if your meters are supported.
3-Wire Meters
For meters with an existing register that provides a standard 3-wire output, the cellular Prism R register connects directly to capture water flow data every minute of every day. The wires can be provided bare (as shown below) or terminated with a specific connector if required by the application.
Other Monitoring Solutions
For meters which don’t provide a 3-wire output, and which don’t provide the top-mounting magnetic coupling, Metron offers two products which provide the flexibility needed to make the connection: Prism EXT and Prism WS.
Prism EXT
The Prism EXT uses a sophisticated magnetic sensor to capture water flow information from third-party meters. This allows a property manager to see consumption data (using WaterScope) in cases where the meter’s existing register is in use by the water utility.
Prism WS
The Prism WS is a cellular monitor/register for existing water meters, using a magnetic sensor to capture water usage data. Easy to install and calibrate, it’s ideal for per-zone and per-building monitoring, as well as commercial and industrial applications.